1911Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
56 Posts
Discussion Starter #1 (Edited)
I just wanted to say thank you again Barry for the excellent work and customer service that I got with you and my Colt Commander.

I purchased the Stainless Series 80 Combat Commander about a month ago. There were a few things that needed looking after. "Big Daddy" referred me to Barry (aka bjg-1911) who lives not too far away from me.

Here is what Barry did to my Colt:

1. Videcki 3 hole trigger
2. Install, smooth frame slots and set overtravel.
3. EGW angle GS bushing .575" Cut and fit to barrel
4. Refit lower barrel feet for Proper lock up and crown
barrel
5. Reliability tune(throat frame and recontour and polish, polish barrel mouth and recontour forhollowpoints, polish chamber and
breechface, bevel firing pin hole,clearance grip safety to remove
without dropping MSH, set extractor tension and polish, deburr bottom of chamber, and smooth disconnector rail, and smooth hammer hooks and sear nose, and check for hammer
follow, set trigger at 41/2 lbs

6. EGW Slide Stop
7. Wilson Extractor


Barry, thanks again for your awesome work and customer service.
:D I now have one heck of a shooter

Monty
 

·
Registered
Joined
·
713 Posts
Monty,

You are very welcome...enjoy your new "blaster":cool:
"Big Daddy" thanks for the referral and TY both for the kind words.:D
Barry
 

·
Registered
Joined
·
1,091 Posts
Glad to hear that Dr. 1911 (as I like to call Barry) got you taken care of properly. I knew he would.

Barry, keep up the good work. I'll be talking to you soon :D
 
1 - 3 of 3 Posts
Top