1911Forum banner
1 - 1 of 1 Posts

47 Posts
There is no reasonable way to convert your .45 to 10mm. It would need a new slide, ejector, extractor, slide-stop, and barrel.

Which may not be a bad thing...I am not sure any compact (sub-Cmmdr) 1911 could reliably handle the slide velocity of a 10mm.

That said, you could buy or load really hot .45s. Its your hand, and your teeth if the slide flies off.


If you just want a 10, you could pick up an EAA Witness for cheap...they are quality guns.

[This message has been edited by telackey (edited 06-10-2001).]
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.