1911Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
334 Posts
Discussion Starter · #1 ·
I have an old frankengun that I want to tighten up the slide on. What i would like to know is what precautions I need to take when tig welding the frame rails. I'm not looking for accuracy, I know this is not a major factor, but I just want it to be a little tighter. Up and down is ok but side to side is more than .020". Any help would be greatly appreciated.

Steve
 

·
Registered
Joined
·
334 Posts
Discussion Starter · #3 ·
Thanks. I read that one a couple of days ago but couldn't find it again.

Steve
 
1 - 3 of 3 Posts
Top