1911Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
The factory sights have to go. I prefer either blank rear/dot front or 1 dot rear/dot front.

What should I be looking at?
 

·
Registered
Joined
·
151 Posts
Mike, I have the GI milspec. I assume the front sight is the narrow tenon & the slide would have to be milled to accept an adjustable rear sight. But I wonder what heighth front sight to use, .330?
 

·
Registered
Joined
·
1,092 Posts
You did not specify if you have a mil-spec RIA or the tactical model. Assuming you have a mil-spec the tang is .055. You can check any of the major companies(Midway, Natchez, etc.) or go to Ebay. If it says its a 70 series you should be fine.
 
1 - 5 of 5 Posts
Top