1911Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter · #1 ·
Anyone have a source for Wilson 10mm mags? Contacted Wilson with no luck. Gee I pick the hard ones dont I?
 

·
Registered
Joined
·
3,157 Posts
Actually, you can use the .45 mags for the 10mm. The lips may need to be tweaked slightly, but typically, they will work with no modifications.

I did find a pair of what was described as Wilson 10's a while back, and they are basically the 45 mags, with a slightly different lip profile, mostly in the rear where the case rim sits. The mags will hold a 45, but because the rear is slightly tight, the case rim tends to not sit back completely, so they don't work very reliably with the larger diameter cases, but are perfect for 10mm/40S&W.

Good luck...
 

·
Registered
Joined
·
90 Posts
Jaydee...

Please describe "tweaked"\

But then again, is two shots less in a mag going to make that much of a difference?
 

·
Banned
Joined
·
1,607 Posts
The 9 round Metal Form 10mm mags work well. The CMC 10 rd .45 mags will work with some lip tuning. The 10 rd. Metal Form .45 mags feed .40 in my Kimber great. BTW you can put 12 rds of .40 in them.
 
1 - 4 of 4 Posts
Top