1911Forum banner

icc 9mm brass??

4.3K views 5 replies 5 participants last post by  JSJAC  
#1 ·
I went to a traing class and ended up with a lot of brass .
Some of the 9mm is marked ICC .Is this brass any good or should I dump it.
 
#2 ·
suggestion

Deprime a few to examine thoroughly; weigh some and compare to known-quality brass; try some with a tested load.
9mm brass is normally forgiving, but some stuff is weird.

As always: "When in doubt throw it out"
 
#3 ·
I didn't find ICC or icc in my list of headstamp markings. I haven't encountered it before. Do as Weshoot suggests. Inspect it, then give it a test. It might be good stuff, but don't be afraid to discard it if you have any reservations.
 
#4 ·
might that be CCI? If so I have been picking up lots (!) of CCI brass after our local Sheriffs Dept. and city Police do their monthly training at our club range. I run it through my Dillon and TMII without a hitch.
R
 
#5 ·
RonT you are probably correct. I don't know why someone didn't think of that before. JSJ was probably reading case upside down....or could be dyslexic(just kidding). Or maybe it is ICC, but I bet you are correct.