After not reloading for over 23 years and with no place to set up my Dillon RL550B, I dragged out my Hornady 007 and after freeing up the stuck ram, I installed my Lee Carbide 38 Super DE capping die and started punching out spent primers. After finishing up the 38 Super brass, I started De-capping 9mm. After a few rounds, the pin slides up and I look inside to make sure I did not get any Berdan primer brass, but the flash hole was extra small. I measured the holes in my other brass and found the holes to be the same size as a #47 drill. I drilled out the undersize flash holes in several and the 9mm went through the die with out a problem.
Has anyone else run into undersize flash holes?
Has anyone else run into undersize flash holes?